Objectives: The purpose of this systematic review is to disclose the impact of autoimmune diseases and their medical treatment on dental implant survival and success.
Material and Methods: A literature search was conducted using MEDLINE (PubMed), The Cochrane Library and Embase up to December 6th, 2021. Any clinical study on patients with an autoimmune disease in whom implant therapy was performed was eligible. The quality of included studies was assessed using the Newcastle-Ottawa Scale. For each autoimmune disease group, data synthesis was divided into three groups: 1) overall results of the autoimmune disease, 2) overall results of corresponding control groups and 3) overall results of the autoimmune disease with a concomitant autoimmune disease (a subgroup of group 1). Descriptive statistics were used.
Results: Of 4,865 identified articles, 67 could be included and mainly comprising case reports and retrospective studies with an overall low quality. Implant survival rate was 50 to 100% on patient and implant level after a weighted mean follow-up of 17.7 to 68.1 months. Implant success was sporadically reported. Data on immunosuppressive medication were too heterogeneously reported to allow detailed analysis.
Conclusions: Overall, a high implant survival rate was reported in patients with autoimmune diseases. However, the identified studies were characterized by a low quality. No conclusions could be made regarding implant success and the effect of immunosuppressants due to heterogeneous reporting.
Objectives: Gingival pigmentation, the most common etiological factor of which is smoking, is a clinical condition that causes aesthetic complaints. Due to the dose-dependent effect of smoking, gingival pigmentation may present regression following cessation. This cross-sectional study aimed to evaluate gingival pigmentation in former tobacco consumers and compare with current ones.
Material and Methods: A total of 110 people, 70 of whom were current smokers (Group CS) and 40 of whom were former smokers (Group FS), were included in the study. Participants filled out the data collection forms containing questions on demographic features and information related to tobacco consumption. In addition, all individuals were examined with Hedin’s melanin index (HMI) to evaluate gingival pigmentation. Statistical significance was set at the P < 0.05 level.
Results: The population consisted of 57.3% male, and the mean age of all participants was 39.43 (SD 12.3) years. The mean duration of tobacco consumption did not differ between groups, whereas the mean HMI score of Group FS was significantly lower (P = 0.001). The correlation analyses showed that while the HMI score of Group CS was in relation to both daily consumption amount and duration of consumption (for both, P < 0.01), the HMI score of Group FS showed a negative association with only time elapsed after cessation (P = 0.000).
Conclusions: Considering the limitations of this study, the outcomes revealed a dose- and a time-dependent relation of gingival pigmentation in smokers. However, gingival pigmentation in former tobacco consumers was negatively correlated only with time elapsed after cessation.
Dental Implant Placement in the Maxilla Following Ridge Augmentation with Free Iliac Bone Graft and Oral Rehabilitation with Fixed Prosthesis: a Three-Year Follow-Up Study
Kristian Kniha, Joud Alhares, Stephan Christian Möhlhenrich, Marie Sophie Katz, Philipp Winnand, Frank Hölzle, Ali Modabber, Marius Heitzer
Objectives: This prospective follow-up study aimed to evaluate the stability values of tapered titanium implants inserted into maxilla following ridge augmentation with free iliac bone graft and crestal bone changes up to three years of follow-up.
Material and Methods: A total of seven patients with 34 tapered titanium implants in the maxilla with fixed protheses were enrolled in this prospective follow-up study. Patients with previously augmented maxillae using free iliac bone grafts were included. Implant stability was measured (Osstell™) for up to three months of healing. Peri-implant bone resorption was measured using radiographic images taken immediately after implant surgery and after three years. Using a clinical and radiological examination survival and success rates were evaluated.
Results: After implant insertion, the stability was 60.93, whereas the stability increased significantly (P = 0.0192) to 64.97 at implant exposure (after 3 months). The mean bone loss around the implants was 1.13 mm after three years. Clinical parameters revealed a mean sulcus depth of 2.76 (1.18) mm and a bleeding on probing score of 0.29 (0.58). The survival rate was 100%, and the success rate was 67.65% at the end of the study.
Conclusions: Tapered implants can be used in free iliac bone grafts for fixed dentures. Implant stability values were high after insertion. In terms of a success rate of 67.65%, the patient’s jaw reconstruction indicated a reduced implant success when comparing the data with healthy patients without any augmentation procedures.
Effect of Organic and Inorganic Nanoparticles on Colour Stability and Mechanical Properties of Heat Vulcanised Maxillofacial Silicone Elastomer: a Comparative Study
Objectives: The purpose of this comparative study in vitro was to evaluate the effect of organic and inorganic nanoparticles on colour stability, tear strength and hardness of maxillofacial silicone elastomer at baseline and when subjected to outdoor weathering for 6 months.
Material and Methods: A total of 240 specimens were fabricated using M511 platinum silicone which were divided into total 4 groups (n = 60) based on the type of nanoparticles (control, polytetrafuoroethylene [PTFE], titanium dioxide [TiO2], zinc oxide [ZnO]) added and each group was further divided into 3 subgroups (n = 20) for colour, tear strength (TS) and hardness (H) testing. The tests were conducted and data was obtained both before and after outdoor weathering of 6 months.
Results: Minimum colour change after weathering was observed in PTFE group (∆E = 2.23). TiO2 group showed maximum TS (12.01 N/mm) followed by PTFE group (10.85 N/mm) before weathering. After weathering, maximum TS was shown by TiO2 group (12.9 N/mm) and PTFE group (12.54 N/mm). TiO2 group showed maximum hardness (24.15 shore A) before weathering and PTFE group showed maximum hardness (33.43 shore A) after weathering.
Conclusions: Within the limitations of this study, it can be concluded that the addition of polytetrafuoroethylene nanoparticles to the polymer enhances both the optical as well as mechanical properties and can be considered favourable for the extended life of the prosthesis.
Objectives: This retrospective study aims to identify incidental findings in cone-beam computed tomography scans of patients irradiated for preoperative evaluation for implant placement and obtained using the same imaging unit as well as the same field of view. The incidence of each incidental finding, as well as the overall incidence, were calculated and the findings were ranked according to their clinical significance.
Material and Methods: A total of 741 cone-beam computed tomography (CBCT) examinations with extended field of view (15 x 15 cm) were retrospectively evaluated for incidental findings (IFs). These were identified, recorded, classified as to their location, and ranked according to their clinical significance.
Results: The vast majority of CBCT examinations presented at least one IF, resulting in a surprisingly high prevalence in total. If extreme anatomical variants are considered (nasal septum deviation, sinus septations etc.), the cumulative prevalence exceeds 99%. IFs of major significance, that may require immediate attention, are beyond 10% in frequency.
Conclusions: We found high prevalence of incidental findings on cone-beam computed tomography examinations performed for preoperative evaluation for implant placement (99.5% if anatomical variants included). Most incidental findings were of minor significance. Although the number of incidental findings that require immediate attention is relatively low, there is a considerable number of cases that need periodic evaluation and/or referral.
Objectives: The objective of this retrospective study was to investigate the incidence of repeated cone-beam computed tomography scans due to motion artefacts in a Turkish subpopulation.
Material and Methods: A total of 6364 patients’ cone-beam computed tomography data were analysed retrospectively to identify repeated scans due to motion artefacts. Patients were divided into eight age groups: 1) < 10-year-olds, 2) 10 to 19-year-olds, 3) 20 to 29-year-olds, 4) 30 to 39-year-olds, 5) 40 to 49-year-olds, 6) 50 to 59-year-olds, 7) 60 to 69-year-olds, and 8) > 70 year-olds. Chi-square test was applied to evaluate the repetition rate of scans by age and gender groups. Statistical significance was set at P < 0.05.
Results: Repeated scans due to motion artefacts were observed in 1.96% of the patients. The repetition rate of scans was significantly higher in males than in females (P = 0.006). Furthermore, the repetition rate of scans was significantly higher in patients < 10 years old compared to the other age groups. However, there was no significant difference in the repetition rate of scans due to motion artefacts among the other age groups (P > 0.05).
Conclusions: The present findings suggest that patient age and gender are associated with repeated cone-beam computed tomography scans due to motion artefacts. Males and children under the age of 10 had more common repeated scans due to motion artefacts.
